Do you have a question about the Heacent TK103A and is the answer not in the manual?
Operating Temperature | -20°C to +60°C |
---|---|
Network | GSM/GPRS |
GSM Frequency | 850/900/1800/1900 MHz |
GPS Sensitivity | -159dBm |
GPS Accuracy | 5m |
Voltage | 3.7V |
Storage Temperature | -40°C to +85°C |
Humidity | 5% to 95% non-condensing |
GPS Tracking | Yes |
Waterproof Rating | IP65 |
SOS Button | Yes |
Geo-Fence | Yes |
History Playback | Yes |
Battery | 3.7V Li-ion battery |
Power Supply | DC 5V |
Time To First Fix | Hot start: 1s |
GPS Module | SiRFstar III |
Details on the tracker's supported features and functionalities.
Instructions for the physical installation of the tracker device in a vehicle.
Step-by-step guide for inserting and configuring the SIM card.
Procedure for powering on the tracker device and initial checks.
Explanation of the LED indicators for GSM and GPS signal status.
How to reset the tracker to its default factory settings via SMS command.
Instructions on how to change the device's access password using SMS.
Details on authorizing specific phone numbers to control and receive alerts from the tracker.
How to obtain the tracker's current location via SMS or by calling the device.
Configuration for continuous automatic tracking based on time or distance intervals.
How the tracker updates its position based on vehicle turning angle for smoother trajectory.
Method to enable or disable GPS data updates when the vehicle is stationary.
Procedure to get the tracker's location as a human-readable street address via SMS.
How the tracker uses LBS for positioning when GPS signals are weak or unavailable.
Switching the device between tracking and monitoring modes via SMS.
Configuration and management of data logging to the SD card, including auto-logging and clearing logs.
How to load tracking data to the monitoring platform, specifying current or past dates.
Setting up the tracker to forward specific SMS messages to other phone numbers.
Command to inquire about account balance or other charges and forward information.
Overview of various alarm functions and their configurations.
Setting up virtual geographic boundaries to trigger alerts when the tracker enters or exits an area.
Managing multiple geofence areas, including setting, deleting, and renaming them.
Setting up an alarm that triggers when the tracker moves from a stationary position.
Configuring the tracker to alert when the vehicle exceeds a predefined speed limit.
Functionality to detect severe impacts and send an accident alert with location.
Alarms related to the vehicle's ACC status, indicating ignition on/off.
Instructions to remotely stop the vehicle's engine via SMS command.
Setting the tracker to an armed state to enable alarm functions, via SMS or remote controller.
Disabling the armed state of the tracker, via SMS or remote controller.
Details the functions and operations of the remote controller for model B.
Specific alarms that are active when the tracker is in the armed state, like door or shock sensor.
Configuring the tracker to operate silently, suppressing siren sounds but still sending SMS alerts.
How alarms behave when the device is outside GSM network coverage.
Commands to check the current status of the tracker, including battery, GPS, ACC, and door status.
Methods to reset the tracker's hardware modules using SMS or a physical reset button.
How to retrieve the unique IMEI number of the tracker device via SMS.
Adjusting the tracker's internal clock and time zone settings using SMS commands.
Changing the communication protocol between TCP and UDP modes for data transmission.
Steps to configure tracker parameters using a USB connection and PC software.
Configuration of GPRS settings, including APN, username, and password for data connectivity.
Activating a mode to reduce GPRS data consumption by disconnecting during idle periods.
Changing the device's operational mode between SMS and GPRS communication.
Information on accessing the web platform and installing PC tracking software.