Heal-Tech SpeedoHealer v3.0 User Manual (English)

To Next Page

SH_UsersGuide_en.pdf - 1 -

http://www.speedohealer.com

SpeedoHealer v3.0

- Electronic Speedo and Odometer Calibrator with Top Speed Memory -

User’s Guide

1. Foreword

Congratulations on your purchase of a SpeedoHealer calibrator unit.

At Heal-Tech Ltd. we are committed to producing the best calibrator devices available and we would

like to thank you for choosing our product.

The installation kits are packed and sold separately. Please find the latest Application list on our

website (or ask an authorized SH dealer) and purchase the Harness Kit suitable for your bike.

After the installation, it is best to use our

on-line calculator to calculate the required calibration value

and to generate the step-by-step programming instructions. You can also download the calculator for

off-line use. Reading this Guide is only necessary if you don’t have Internet access to our website.

2. Setting and Using your SH

2.1 Assigned functions to SH switches

Switch no. in

ON position

Selected Function Possible values set by the button

1 Test mode on/off

Change the emitted frequency

(x 2, in 10 steps)

2 Set the Conversion mode value

0: no conversion

1: mile → km

2: km → mile

3 Set the Sign of Calibration value

0: Negative

1: Positive

4 No. of Tens in Calibration value 0..9

5 No. of Ones in Calibration value 0..9

6 No. of Tenths in Calibration value 0..9

All Reset Press to confirm

2.2 Programming the unit

1. At first, you have to determine the Calibration and Conversion mode values needed for

your application. If you can’t access the on-line calculator, refer to chapter 3.

Normally the Conversion mode value is zero, unless you have an import bike/speedo with

different units of measure than in the country you live in.

2. It is recommended to start the programming sequence by a Reset command.

Set all switches to ON position and turn the ignition On. The LED blinks once.

[After a few seconds the product identification code is transmitted via the LED - ignore]

Press the button, the LED lights up. Release the button.

If you wish to set the unit into Transparent mode, then flip all switches down while the

ignition is still on. The LED flashes rapidly for 3 seconds to confirm that all parameters

have been cleared (factory default). Otherwise, continue with the next step.

Need help?

Do you have a question about the Heal-Tech SpeedoHealer v3.0 and is the answer not in the manual?

Heal-Tech SpeedoHealer v3.0 Specifications

General

Model	SpeedoHealer v3.0
Category	Test Equipment
Manufacturer	Heal-Tech
Resolution	0.1%
Display	LCD
Operating Temperature	-20°C to +60°C
Storage Temperature	-30°C to +70°C
Vibration resistance	Yes
Compatibility	Various motorcycles
Memory	Non-volatile
Interface	Buttons for adjustment
Power Supply	12V DC
Function	Calibrates speedometer and odometer readings on motorcycles, ATVs, and other vehicles.