- 4 -
5. Troubleshooting
1. Make sure you are running the latest app version (Menu → About).
Otherwise, update from the Google Play Store.
On some phones, you need to press a button longer to open the menu.
2. Start the engine and let it idle.
Make sure the QSE LED light turned to solid GREEN.
3. Connect to the module and make sure the app shows "Connected".
Check whether the RPM indication under Settings is correct.
4. Press the Reset to defaults button (at the bottom of the Settings screen).
5. Under the Settings, set the Cut-off test to 140ms.
Press the test button and see if the engine stops for a short time or not.
The engine should stop momentarily (or even completely) when you push the Cut-
off test button. This proves the module's output is working.
Otherwise, disconnect the module and connect the supplied 4-pole Jumper-plug.
6. Under the Settings menu, start the Sensor logging and follow the instructions on
the screen:
- Put the bike on a rear stand and have the side stand UP.
- Put the gearbox in TOP gear. Sit on the bike normally.
- Without the engine running, or with the engine running at idle and clutch pulled
in, do a SHIFT UP motion 6 times with your normal shift speed and force.
- See the average value of the six shifts and divide by two.
- Set this number for the Sensor threshold. E.g. if you see the six shifts ranging
from 35 to 45, then set 20 for Sensor threshold.
7. Press Menu → Upload to store the changes in the module.
8.
Road test the bike and do full throttle clutchless upshifts. Fine tune the Sensor
threshold if necessary:
- If the shift lever is too hard, adjust the threshold LOWER.
- If you experience unwanted cut-offs e.g. when touching the shift lever lightly,
adjust the threshold HIGHER.
- If you still experience a problem with the shifts, mount the sensor in an
alternative position. Refer to the sensor install guide.
6. Warranty
To ensure trouble-free operation from the start, all units have been extensively tested
prior to shipment. For this reason, please make sure you followed the install steps
carefully and check the connections and settings before you report a problem.
Our dealers are offering a 30-day money-back guarantee on HealTech products if the
product does not fulfill your expectations. (All parts must be returned in original
condition for full refund.)
Furthermore the product is covered by our 2-year replacement warranty from the date
of purchase. The warranty does not apply to product that has been subjected to misuse,
fitted incorrectly or there’s a visible damage.
Web: www.healtech-electronics.com
Email: support@healtech-electronics.com
To Previous Page
Loading...