What to do if HealthSTATS BPro Blood Pressure Monitor LCD is blank?
If the LCD screen of your HealthSTATS Blood Pressure Monitor is blank, the battery is likely flat. Replace it with a new battery.
What to do if my HealthSTATS BPro shows a full, non-pulsating bar?
A full, non-pulsating bar on your HealthSTATS Blood Pressure Monitor could indicate signal over-saturation, possibly due to the device being strapped too tightly. Here are some steps to resolve this: * Loosen or re-strap your BPro, referring to the section “Mounting the BPro on the patient” for guidance. * Give the plunger a light tap to dislodge any particle that may have hindered its movement. * Keep your wrist still during measurements. Also, records are available only when you have successfully calibrated your BPro and taken BP readings.
How to fix no pulsation bar on HealthSTATS Blood Pressure Monitor?
If your HealthSTATS Blood Pressure Monitor shows no pulsation bar, it could be due to the sensor not being in the ideal position to take readings. Adjust the sensor so that the plunger rests on the spot with the strongest pulsations (refer to the section “Mounting the BPro on the patient”).
What to do if my HealthSTATS BPro Blood Pressure Monitor shows a low-battery level?
If your HealthSTATS Blood Pressure Monitor indicates a low-battery level, replace the old battery with a new one.
General| Brand | HealthSTATS |
|---|---|
| Model | BPro |
| Category | Blood Pressure Monitor |
| Language | English |
To Next Page