Hear Technologies Hear back pro - Quick Start Guide Manual

Connect the appropriate input(s) as shown in the hook-up diagram.
Select the desired input using the front panel switch.
Connect Hear Back PRO Mixers to the Network Card outputs
using CAT6* cables.
Turn on Hub Power.
Set all Mixer Channels and Master Volume levels to 0%.
Connect the headphones, in-ear monitors, and/or line outputs
for connecting to wireless in-ear systems, powered monitors, or
other devices requiring line-level inputs.
WARNING
• The Hear Back PRO is capable of
driving most headphones to extreme
levels that can damage your HEARING!
• ALWAYS turn down the Mixer “Master”
volume down before putting on in-ear
headsets or headphones.
!
HOOK-UP DIAGRAM
CONNECTING THE SYSTEM
1
3
5
6
QUICK START GUIDE
2
Thank you for purchasing the Hear Back PRO 16-channel personal monitor mixer system!
Use this Quick Start Guide to setup quickly and easily. Refer to the User Guide for complete
instructions, available online at www.hearback.com/support or scan the QR code above.
1
2
3
4
Hear Back PRO is proudly designed & assembled
in the U.S.A. by musicians and audio engineers.
SCAN
CODE
FOR USER
GUIDE
HUB REAR PANEL
HUB FRONT PANEL
5
5
5
6
6
6
5
6
4
*Cable complying with the National authorities (cable with an outer jacket or sleeving rated VW-1 or better).