How to fix no spark at ODS/pilot on HearthRite Heater?
If there is no spark at the ODS/pilot of your HearthRite Heater when the ignitor button is pressed, try these steps: Replace the ODS or the electrode. Check the cable to ensure it is securely connected to the ignitor and ODS. Make sure the ignitor cable is free from any pinching by metal or tubing and keep it dry. If none of these work, replace the ignitor cable.
What to do if gas odor exists even when control knob is in OFF position in HearthRite Heater?
If you notice a gas odor even when the control knob of your HearthRite Heater is in the OFF position, it means there is a gas leak. You should locate and correct all leaks. If you are unable to resolve the issue, contact customer service.
What to do if HearthRite HVF2R18N-2 shuts off in use?
If your HearthRite Heater shuts off while in use, but the ODS (Oxygen Depletion Sensor) is still operating, try opening a window and/or door to increase ventilation. You can also contact your local gas supplier or clean the ODS/pilot.
Why HearthRite HVF2R18N-2 has spark but no ignition?
If your HearthRite Heater shows a spark at the ODS/pilot when the ignitor button is pressed, but there's no ignition, first, ensure the gas supply is turned on or the equipment shutoff valve is open. Next, fully press in the control knob while pressing the ignitor button. Continue holding down the control knob and repeat the igniting operation until air is removed. You may also need to clean or replace the ODS/pilot assembly, or replace the gas regulator. Ensure the control knob is in the PILOT position. If problems persist, contact your local propane gas company.
Why HearthRite HVF2R18N-2 pilot light goes out when control knob is released?
If the ODS/pilot light of your HearthRite Heater ignites, but the flame goes out when you release the control knob, make sure to press the control knob fully. After the ODS/pilot lights, keep the control knob pressed in for 30 seconds. Ensure the equipment shutoff valve is fully open. Hand tighten gas connections until snug, then tighten ¼ turn more. If the issue persists, consider replacing the ODS or contacting customer service.
What to do if there is a gas odor during combustion in HearthRite Heater?
If you smell a gas odor during combustion in your HearthRite Heater, disassemble the gas tubing and remove any foreign matter. Then, locate and correct all leaks.
Why is there a high yellow flame during burner combustion in my HearthRite HVF2R18N-2?
If you notice a high yellow flame during burner combustion in your HearthRite Heater, check the burner for dirt and debris and clean it if necessary. You may also need to replace the gas regulator or contact your gas supplier.
Why does my HearthRite HVF2R18N-2 Heater produce unwanted odors?
If your HearthRite Heater produces unwanted odors, ventilate the room and stop using odor-causing products while the heater is running. Locate and correct any gas leaks. If you have a propane model, refill the supply tank.
What to do if Burner(s) does not light after ODS/pilot is lit in HearthRite Heater?
If the burner(s) of your HearthRite Heater do not light after the ODS/pilot is lit, clean the burner orifice or contact customer service. You may also need to contact your gas supplier.
Why is the burner backfiring during combustion in my HearthRite HVF2R18N-2?
If the burner is backfiring during combustion in your HearthRite Heater, clean the burner orifice or contact customer service. You can also contact your dealer or customer service, or replace the gas regulator.
General| Model | HVF2R18N-2 |
|---|---|
| Category | Heater |
| Fuel Type | Natural Gas |
| Heating Capacity/BTU Input | 18, 000 BTU |
| Venting | Vent-Free |
| Color | Black |
| Efficiency | 99.9% |
To Next Page
