This document provides instructions for retrofitting
Fireye BurnerLogix controls (Figure 1) to Heatec
HC and HCS heaters. Fireye and BurnerLogix are
trademarks of Fireye, a Kidde Company.
The new Fireye BurnerLogix controls include the
following units:
• Display Module BLV512
• Burner control YB110 with Programmer
Module YP100
These new controls replace older Fireye Flame
Monitor E110 used on control panels (Figure 2)
of HC and HCS heaters until recently. The older
controls are being phased out and will be available
only for a limited time.
The new controls provide some advantages over
the older Flame Monitor controls. Consequently,
some owners may want to upgrade to the new
controls even though the older ones are operating
satisfactorily at the present time.
Retrofitting Fireye
®
BurnerLogix
™
Controls
on Heatec HC and HCS heaters
Publication No. 2-09-211
Figure 1 New Fireye Burner Logix controls.
ALARM
HORN
OFF
RESET
OPEN
CIRC. PUMP
OFF
ON
HEATER CONTROL
OFF
ON
HEATER ALARM
OFF
ON
GAS
OIL
POWER ON
MANUAL
RESET
AUX. PUMP #1
OFF
ON
AUX. PUMP #2
OFF
ON
AUX. PUMP #3
OFF
ON
BLOWER ON
LIMITS MADE
LOW FUEL
GAS PRESS.
HEATER ALARM
COMB. AIR
AUX. CONTACTS
HIGH FUEL
GAS PRESS.
OIL VALVE ON
HIGH MEDIA
TEMP.
LOW FUEL
PILOT PRESS.
GAS VALVE ON
LOW FUEL
OIL PRESS.
LOW MEDIA
LEVEL
PILOT GAS VALVE
ON
HEATER FUEL
OIL PUMP
AUX. CONTACTS
HEAT DEMAND
E
M
E
R
G
E
N
C
Y
-
S
T
O
P
E
M
E
R
G
E
N
C
Y
-
S
T
O
P
HIGH FLUE GAS
STACK TEMP.
CIRC. PUMP
AUX. CONTACTS
LOW MEDIA
DIFF. PRESS.
HIGH MEDIA
DIFF. PRESS.
FUNCTION
DISPLAY
RESET
SET UP
AUTO
TUNE
RUN
HOLD
Honeywell
ALM
OUT
PV
HIGH MEDIA
TEMP. CONTROLLER
345
F
MODULATING
CONTROLLER
SETPOINT
SELECT
RUN
HOLD
Honeywell
ALM
DI
%
RSP
OUT
MANUAL
AUTO
LOWER
DISPLAY
FUNCTION
LOOP 1/2
SET UP
SP 350
345
F
A
SCRL
MODE
RESET
FLAME-MONITOR
AUTO
FLAME SIGNAL
40
Figure 2. Typical control panel using old Fireye Flame Monitor.
HEATEC TEC-NOTE
To Next Page
General