Heath Zenith 7352 - Tune Settings; Selectable Chime Tunes; Tune Setting Table

4
ON
1 2
WARNING: Disconnect chime unit from power source before
opening chime access door. Close door and replace screw before
reconnecting to power.
Tune Settings
ON
1 2
ON
1 2
1 – MODE
2 – TUNE
Push Button / Sensor Chime Tune
Switch 2 - ON Switch 2 - ON Ding
Switch 2 - OFF Switch 2 - ON Ding-Dong
Switch 2 - OFF Switch 2 - OFF Ding-Dong
Switch 2 - ON Switch 2 - OFF Westminster
Tune Setting Table
The chime has different selectable tunes: Ding (one note tune), Ding-Dong
(two note tune), or Westminster (eight note tune). The factory setting is for the
Westminster tune. This tune can be changed by following the instructions in the
Tune Setting Table. Note: Only use switch 2 when changing the chime tune.
Note: All chime models are designed to work with up to 5 transmitters (push
buttons and/or sensors – sold separately). All chimes are designed to play only
two different tunes no matter how many transmitters are used.
Inside Chime Access DoorInside Push Button Inside Sensor