Model SL-4100
Features
• Light comes on when motion is detected.
• Automatically controls existing post light.
• DualBrite
®
Timer.
• Photocell keeps the light off during daylight
hours.
This package includes:
© 2007 HeathCo LLC 595-5657-04
TEST
Requirements
• The light control requires 120 volts AC.
• If you want to use Manual Override, the
control must be wired through a switch.
• Some codes require installation by a
qualified electrician.
Motion Sensing Post
Light Adapter
3 Wire Connectors
3 Screws
Post Light
Adapter
ON-TIME
MINUTES
ACCENT
Put ON-TIME switch on the sensor bottom
to TEST and the DualBrite
®
(ACCENT)
switch OFF.
MANUAL MODE
... back on.
1 Second
OFF then...
OPERATION
AUTO
Set ON-TIME switch to
1, 5, or 20 minutes.
Manual mode only works at
night because daylight re-
turns the sensor to AUTO.
Flip the light switch off for
one second then back on to
toggle between AUTO and
MANUAL MODE.
Manual mode works only
with the ON-TIME switch in
the 1, 5, or 20 position.
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
1
/
2
minutes for the circuitry to calibrate.
Mode: On-Time Works: Day Night
Test 5 Seconds x x
Auto 1, 5, or 20 Min x
Manual To Dawn* x
Accent 3, 6 Hr, to Dawn x
DUSK TO DAWN
6 HOUR
3 HOUR
OFF
20
5
1
TEST
20
5
1
TEST
Before installation, record the model number
from back of fixture below. Attach receipt in
case of possible warranty issues.
Meets the ENERGY STAR
®
guidelines when DualBrite
®
function is off and ON-TIME
is 1 or 5 minutes.
To Next Page
General