The steps performed in this Pictorial are in
this area of the circuit board.
PART
NUMBER
IDENTIF (CATION
DRAWING
AX
CONTINUE
3"
gray
wire at hole AJ. The free
end will be connected later.
?V 1 3" green wire from hole AU to hole
AK.
5" violet wire at hole U. The free
end will be connected later.
N)
Connector pin at hole T.
( ) Connector pin at hole Y.
0
0 0
BX
'A'
Z
,g) 0
AN
1 Connector pin at hole Z.
t-.4) Connector pin at hole X.
1 Solder the pins to the foil. Also, bi
sure the wires are soldered and th
,
excess ends cut off.
) Compare the foil area with th
N
X-Ray View (on Page 29) to be sur
there are no solder bridges.
PICTORIAL 2-5
AK
1-0
F-
6 (---)
M
0
—
CB—
Page 10
START
AP'
'ici
►
Two strips of twelve connectors.
N
"NI-)
Use
the
assembled tool
plates to
remove the connecting bands. First
bend each band inward, and then
outward, as shown (several times if
necessary). Do not bend the connec-
tors.
TOOL PLATES
BANDS
6
L
/
J
•,...
i
1
1
I
BEND
1
HERE
IC CONNECTORS
(
)
Cut a 5-1/2" length of 8-wire cable
and separate the cable into eight
individual wires. You will use these
wires in the following steps.
'---------------------_
1
---
SEPARATE
—
f=
8- WIRE
CABLE
NOTE: In
the following steps, when a wire
is called for, cut the wire to the indicated
length, remove 1/4" of insulation from the
wire_ends, twist the strands together, and
apply a small amount of solder to the bare
ends. Solder each wire as it is installed and
cut off the excess bare wire ends.
4
-
\i )
2-5/8" brown wire.
,
\\/)
2-3/8" red wire.
N
IV
1
2-7/8" orange wire.
-
4
\1
1
5-1/4" yellow wire from hole AX to
hole BX.
Route it as shown.
ts
t•-1 )
2
-
1/2"
red wire from hole M to hole
AN.
0
3/4 y
1/
4
2
1 "
2"
3"
4"
5"
6
1111131
11
1
1
t1
1
To Next Page
Loading...