A
Page 11
START
2-1/4" green wire from hole AT to
hole AR. Do not shorten this wire.
/ 3" blue wire at hole J. The free end
will be connected later.
Cut a 10" length of 8-wire cable
and:
1.
Separate the brown and red
wires from the cable, leaving
the brown wire connected to
the red wire.
2.
Separate the orange wire from
the cable.
3.
Separate the yellow wire from
the cable.
4.
Separate the green and blue
wires from the cable.
Leave
the
green
wire
connected to the blue wire
and the violet wire connected
to the gray wire.
) 8" orange wire
hole AS. The free
somosmowellesmommoimomouset
end will be connected later.
NOTE: The power line frequency in the
E U.S.A. is 60 Hz.
Do not
perform the
E following
step unless you live in an area
:(or a foreign country) that has a 50 Hz
:power line frequency.
E( )
3" yellow wire from hole BY to hole =
BZ.
3malmmammuommmisassammed
:NOTE: Most clocks indicate up to 12
E
:hours (0
-
12)
and then repeat. Do not :
:perform the following step unless you :
:want your Clock to indicate 24-hour time
(0-24).
:( )
3-1 /4" yellow wire from hole AY to
hole A2.
ammimmemsimillommasemmil
CONTINUE
Prepare the gray and violet wire pair
as shown.
7"
1/4"—•-:
Install
end
A
of the wire
combination as shown.
Violet wire to hole AB.
Gray wire to hole AA.
1 Cut the green and
blue wire pair to a
length
of 9
-
1/2" and
prepare the
ends the same as the previous pair.
(
Install
the
wire combination as
shown.
PICTORIAL 2-6
Blue wire to hole AD.
Green wire to hole AC.
) Check to be sure all wires are
soldered.
To Next Page
Loading...