Need help?Do you have a question about the Heathkit HG-10B and is the answer not in the manual?
General| Brand | Heathkit |
|---|---|
| Model | HG-10B |
| Category | Transmitter |
| Language | English |
Describes the oscillator stage of the VFO circuit.
Details the cathode follower stage for isolation.
Explains the voltage regulator circuit for stable operation.
Describes grid block and cathode keying methods.
Outlines the three positions of the function switch.
Detailed instructions for assembling the dial mechanism.
Step-by-step guide for mounting components on the chassis.
Instructions for connecting wires within the chassis.
Steps to connect the chassis to the dial mechanism.
General wiring procedures throughout the unit.
Specific steps for wiring the pilot lamps.
Final assembly and wiring tasks for the chassis.
Instructions for assembling the dial drive system.
Final steps to assemble the unit's exterior.
Installation procedure for specific Heathkit transmitters.
Installation procedure and circuit changes for the DX-40.
Considerations for installing with other transmitters.
Details on keying connections for different setups.
Guidance on VFO supply voltage requirements.
Steps to set the dial indicator for accurate readings.
Instructions for positioning the dial pointer.
Adjusting the variable capacitor for proper meshing.
Pre-calibration adjustments for coils and trimmers.
Detailed steps for aligning coils and trimmers.
A table listing common problems and their causes.
To Next Page
