Heathkit HP-23A - Initial Tests and Checks

==
__
Page 11
( ) Connect one of the line cord wires to lug 1
of
circuit
breaker
P
(S-1),
(_) Connect the remaining line cord wire tolug 6
of terminal strip J (S-3) [S-2 if wired for
240 V.) Pull any excess line cord back
through grommet C, and position the portion
that
is
is
inside
the
chassis
as
shown,
This completes the wiring of the Power Supply.
Carefully
examine
all
connections,
looking
for
unsoldered
connections,
short
circuits,
and
loose
wires
or
components,
Make
sure
that
none
of
the
lugs
of
socket
B
are
touching
each
other.
Tip
and
shake
the
Power
Supply
to
dislodge
any
wire
clippings
or
bits
of
solder
that
may
have
fallen
into
the
wiring,
then
proceed
to
the
Final
Assembly
section
that
follows,
FINAL ASSEMBLY
Refer to Pictorial 5 for the following steps,
(_) Install four rubber feet on the bottom plate.
Use 8-32 x 3/8" screws, #8 lockwashers,
and 8~32 nuts,
() Install the blue and white label on the
bottom plate at the location shown in Pic-
torial
5,
Carefully
peel
away
the
backing
paper
and
press
the
label
into
position,
Be
sure to refer to the numbers on this label
in
any
communications
you
have
with
the
Heath
Company
about
this
kit.
TAKING CARE NOT TO CUT THE INNER CONDUCTORS.
THE OUTER INSULATION OF THE CABLE
sover” PAL
>
Detail 5A
() Install the bottom plate on the chassis
with #6 x 3/8" sheet metal screws,
(_) Install the cabinet shell on the chassis, Use
#6 x 3/8" sheet metal screws,
Power Cable
(_) Refer to Detail 5A and prepare one end of
the 8-wire cable,