Heathkit SB-401 - FACTORY REPAIR SERVICE

Page 120
HEATHEIT
TRANSMITTER DIFFICULTIES POSSIBLE CAUSE
Weak spotting signal,
Low drive on the 7,0
and 14,0 MHz bands,
Instability.
1.
Wire from antenna relay to RCVRANT jack
not positioned close enough to bare wire con-
nected between lugs 5 of tube sockets V10
and Vil,
1. 8 MHz trap set improperly,
1,
2.
3.
4
Open ground connections to shielded cable,
Poor lead dress,
Loose hardware,
Improper neutralization,
FACTORY REPAIR SERVICE
You
can
return
your
completed
kit
to
the
Heath
Company
Service
Department
tohave
it
repaired
for
a
minimum
service
fee,
(Kits
that
have
been
modified
will
not
be
accepted
for
repair.)
If
you
wish,
you
can
deliver
your
kit
to
anearby
Heath
Authorized
Service
Center,
These
centers
are
listed
in
your
Heathkit
catalog,
To be eligible for replacement parts under the
terms of the warranty, equipment returned for
factory repair service, or delivered to a Heath
Authorized Service Center, must be accompanied
by the invoice or the sales slip, or a copy of
either, If you send the original invoice or sales
slip, it will be returned to you,
If it is not convenient to deliver your kit toa
Heath Authorized Service Center, please ship it
to the factory at Benton Harbor, Michigan and
follow the following shipping instructions:
Prepare a letter in duplicate, containing the
following information:
Your name and return address,
Date of purchase,
A brief description of the difficulty,
The
invoice
or
sales
slip,
or
a
copy
of
either,
Your
authorization
to
ship
the
repaired
unit
back
to
you
C,O,D,
for
the
service
and
shipping
charges,
plus
the
cost
of
parts not covered by the warranty,
Attach the envelope containing one copy of
this letter directly to the unit before pack-
aging, so that we do not overlook this impor-
tant information, Send the second copy of the
letter by separate mail to Heath Company,
Attention: Service Department, Benton Harbor,
Michigan,
Check the equipment to see that all parts and
screws are in place, (Do not include wooden
cabinets when shipping receivers, tuners, am-
plifiers, or TV sets, as these are easily
damaged in shipment,) Then, wrap the equip-
ment in heavy paper, Place the equipment in
a strong carton, and put at least THREE
INCHES of resilient packing material (shredded
paper, excelsior, etc.) on all sides, between
the equipment and the carton, Seal the carton
with gummed paper tape, and tie it with a
strong cord, Ship it by prepaid express, United
Parcel Service, or insured parcel post to:
Heath Company
Service Department
Benton Harbor, Michigan 49022
|
|