Need help?Do you have a question about the Heatit Z-WATER and is the answer not in the manual?
Guidance on stripping wires and tightening connectors to 0.5 Nm.
Description of terminals for connecting the 230V AC mains power supply.
Description of terminals for the 4 analog inputs.
Description of terminals for the 24V DC power supply output.
Description of terminals for the 10 relay outputs, including Common and NO.
Details on the analog temperature inputs and thermistor type configuration.
Explains that relay outputs are Normally-Open contact outputs for switching loads.
Configures the status LED's state, on/off, or flashing intervals.
Sets the brightness level of the status LED as a percentage.
Selects the type of thermistor for input 1, or disables the input.
Selects the type of thermistor for input 2, or disables the input.
Selects the type of thermistor for input 3, or disables the input.
Selects the type of thermistor for input 4, or disables the input.
Configures the functionality and calibration offset for input 1.
Configures the functionality and calibration offset for input 2.
Configures the functionality and calibration offset for input 3.
Configures the functionality and calibration offset for input 4.
Sets the time interval for temperature reports from input 1.
Sets the time interval for temperature reports from input 2.
Sets the time interval for temperature reports from input 3.
Sets the time interval for temperature reports from input 4.
Lists all Command Classes supported by the Z-Wave Device, including security levels.
General| Product Category | Controller |
|---|---|
| Protocol | Z-Wave |
| Operating voltage | 3V DC |
| Operating Humidity | 0 - 95 % |
| Range | Up to 100 m |
| Z-Wave Chip | Z-Wave 700 |
To Next Page