HEATRAY IRH-E ELECTRIC SERIES User Manual

HEATRAY
®
IRH-E
INFRARED RADIANT HEATING - ELECTRIC SERIES
PUBLICATION IRH-E 010111-2US
PRODUCT MANUAL
IRH-E HEATERS
FOR INDOOR AND OUTDOOR PERMANENT STRUCTURES
This appliance shall be installed in accordance with:
This appliance must be installed by an authorised person and all
electrical work must be carried out by a qualified electrician to validate
the warranty.
- Manufacturer’s Installation Instructions
- Local Requirements for Electrical Equipment
- Municipal Building Codes
- Any other relevant Regulatory Regulations
IMPORTANT
The appliance is not intended for use by young children or infirm persons
without supervision. Young children should be supervised to ensure that
they do not play with the appliance.
The heater must not be located immediately below a socket outlet.
The fixed wiring shall incorporate all means for disconnection from the
supply, having an air gap contact separation in all active (phase) conductors,
all done in accordance with local wiring rules.
a.
b.
c.
Head Office & Export Enquiries: Tel: +613 9555 3667 Fax: +613 9555 9723
2 Powlett Street, Moorabbin, PO Box 3093, Moorabbin East LPO, Vic. 3189 Australia.
CELMEC INTERNATIONAL PTY LTD ABN 66514 732 689
heatray
®
Infra-Red Radiant Heater IP65
Model No. IRH-E 1500
Capacity 1.5kW
Voltage 120V / 1PH / 60Hz
THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN
SERIAL NUMBER:
QA INSPECTED BY:
3179365
USA-1.5KW_PL.indd 1 17/2/10 3:39:31 PM

HEATRAY IRH-E ELECTRIC SERIES Specifications

General

Brand	HEATRAY
Model	IRH-E ELECTRIC SERIES
Category	Heater
Language	English

Summary

Heatray IRH-E Infrared Radiant Heater Manual

Installation Compliance Requirements

Appliance installation must comply with manufacturer instructions and local regulations.

Standard Warranty Policy

Warranty Limitations and Exclusions

Details obligations, exclusions, and conditions for product warranty claims.

Important Safety Instructions

Installation Guide

Cleaning and Maintenance Procedures

Customer Service Information

Mounting Bracket Options

Ceiling Suspension Bracket Arrangement

Details on the standard arrangement for suspending the heater from the ceiling.

Wall Mount Bracket Arrangement

Details on the standard arrangement for mounting the heater on a wall.

Umbrella Heater Mounting Bracket

Heatray Umbrellas Field Wiring Example

Electrical Conduits and Wiring Requirements

Specifies conduits and external wiring for umbrella heater structures, including cable types.

Heater Field Wiring Example

Control Module CM4IRH-US

Site Wiring - Supply Conductors

Details on supply conductors from the main switchboard to the control module.

Site Wiring - Wall Remote Control

Wiring connections for the wall remote control switch to the control module.

Site Wiring - HeatRay Heaters

Wiring connections for HeatRay heaters to the control module.

Site Wiring - Celights

Wiring connections for Celights to the control module.

IRH-E Heater Clearances

IRH-E Heater Tilt Angle

Wall Mounted Tilt Angle

Illustrates acceptable tilt angles for wall-mounted IRH-E heaters.

Ceiling Mounted Tilt Angle

Illustrates acceptable tilt angles for ceiling-mounted IRH-E heaters.

Product Specifications

Commissioning and Service Sheet