Why HeatSeal 200ES Film Cut-off Rod does not work?
If the Film Cut-off Rod on your HeatSeal Stretch Wrapping Systems isn't working, first ensure the unit is plugged into a 15 Amp circuit and the power switch is in the “ON” position. Next, check the 1 Amp circuit breaker; if it's tripped, reset it, and then inspect the wiring and connections to ensure there are no shorts to ground.
How to fix HeatSeal Stretch Wrapping Systems film cuts too slowly?
If the film cuts too slowly on your HeatSeal Stretch Wrapping Systems, clean the Cut-off Rod surface and make sure it is not bent.
What to do if HeatSeal Stretch Wrapping Systems Seal Plate does not work?
To troubleshoot a HeatSeal Stretch Wrapping Systems unit with power but a non-functional Seal Plate, start by checking the 20 Amp Circuit Breaker. If it has tripped, reset it after inspecting the wiring and connections for shorts to ground. If resetting isn't possible, replace the Circuit Breaker. Also, ensure the Photo eye is working correctly: a green light should be on, and a yellow light should appear when triggered. If the yellow light doesn't come on, replace the Photo Eye. If the green light isn't on, check the Control Board. Verify the Control Board by checking the voltage on Pin 1 (should be 120vac) and across Pins 4 & 5 (should be 10 to 30vdc); replace the Control Board if there's no voltage, otherwise, replace the Photo Eye. Finally, if the Seal Plate is not heating up, replace ...
General| Brand | HeatSeal |
|---|---|
| Model | 200ES |
| Category | Stretch Wrapping Systems |
| Language | English |
To Next Page