Step 13
Attach the side burner hose (No.29) and regulator hose (No.30) as shown in the diagram below.
Tighten all connections with a spanner. A propane regulator (not supplied) now needs to be
connected to the regulator hose. Grease the receptor on the regulator and push fully on the
hose. Grip should then be secured by tightening screw. The regulator should now be connected
to a PROPANE gas bottle (not supplied). Follow the instructions for use as supplied with your
regulator.
PERFORM LEAK TEST, as described in next section, prior to use.
To Next Page