12 / 25
PL
SK
EN
CS
HU
• This product is designed in accordance with all applicable safety requirements and standards
applicable to it. All repairs should be only made by qualified person and spare parts replaced
by original parts, otherwise the user may be in serious danger.
• Regularly check the supply cable and check for signs of damage or aging.
• Avoid accidental starting.
• Use only extension cables with sufficient section, which are approved for this purpose and
labelled accordingly.
• Cable drum before using completely unwind.
Note: I
It is good to have the extension cable in a distinctive colour in order to not to overlook,
cross, cut through or trip over it.
WARNING! B
Do not connect a damaged cable or touch the damaged cable before disconnecting
from the network. This can cause an electric shock. In case of damage to the supply,
have it replaced by an authorized service centre. This prevents a dangerous
situation.
C The maximum temperature of the liquid to be pumped in continuous operation
should not exceed +35 °C. This pump is not to be used to pump combustible,
gaseous or explosive fluids. The pumping of aggressive fluids (acids, alkalis, silo
seepage etc.) and abrasive substances (sand) should also be avoided
C Never let the pump run dry and never operate it with fully closed flow.
The manufacturer’s warranty shall lapse if the pump is damaged due to it being
allowed to run dry and no flow.
PREVENTION AND FIRST AID
Note: I
We recommend always having:
- A suitable fire extinguisher (snow, powder, halotron) at your disposal.
- A fully equipped first-aid kit, easily accessible for accompaniment and operator.
- Mobile phone or other device for quickly calling emergency services.
C Always follow the principles of first aid in case of any injuries.
• If there is a cut, cover the wound with a clean bandage (fabric) and press down firmly to
stop the bleeding.
• When an electric shock is caused, it is necessary more than anywhere else to put emphasis
on safety and risk elimination for the rescuers. The affected person usually stays in contact
with electrical equipment (source of injury) because of muscle spasms caused by the electric
shock. Traumatic process continues in this case. It is therefore necessary to TURN THE
POWER OFF FIRST using any possible way. Subsequently CALL AN AMBULANCE or other
professional service, and then PROVIDE FIRST AID! Ensure free airways, check breathing,
check pulse, put the affected flat on their back, bend their head and stick out their lower
jaw. If necessary, begin with artificial respiration into the lungs and heart massage.
To Next Page
Loading...
