13 / 25
PL
SK
EN
CS
HU
IN CASE OF FIRE:
• If the motor starts to burn or it the smoke appears from it, turn the product off, disconnect
power supply and move away to safety.
• To extinguish the fire, use suitable fire extinguisher (CO
2
, Dry Powder, halotron).
• DO NOT PANIC. Panic can cause even more damage.
RESIDUAL RISKS
Even if the product is used according to instructions, it´s impossible to eliminate all the risks
associated with its operation. The following risks may occur arising from product construction:
• Electrical hazard caused by touch with live electrical parts (direct contact) or with parts,
which came under voltage due to failure of the product (indirect contact).
• Dangers caused by unexpected starting, unexpected exceeding of engine revs caused by
defect / failure of control system, relate to the defects by the handle and placing of drivers.
• Dangers caused by impossibility to stop the product in best conditions, relate to solidity of
the handle and placing of engine shut down product.
WARNING! B
The product produces an electromagnetic field of a very weak intensity. This field
may interfere with some pacemakers. To reduce the risk of serious or fatal injury,
persons with pacemakers should consult the use with their physician.
ELECTRICAL REQUIREMENTS
• Never use at the nominal voltage other than 230V/50Hz. The circuit must be properly and
accordingly current protected.
• Only connect to an electrical circuit that is protected by the current protector with actuating
current not exceeding 30 mA.
UNPACKING
• Carefully remove the product from the box.
• Carefully inspect all parts.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. Do not let children play with plastic bags, foils or small
parts. There is a danger of swallowing or suffocating!
• If you notice damage while unpacking or the delivery is incomplete, notify your supplier
immediately. Do not operate the machine!
• We recommend save the package for future use. The packaging materials must still be
recycled or disposed of in compliance with the relevant legislation. Sort different parts of
the packaging according to material and hand it to the appropriate collection sites. For
further information contact your local administration.
PACKAGE CONTENTS
1pc pump float switch, 2pcs aluminum tube, 1pc tube with a stopcock, 6pcs sealing ring, 2pcs
threaded connector, 1pc cable holder
To Next Page
Loading...
