To Next PageTo Next PageWhy HEIN-WERNER AUTOMOTIVE HW93642 Jacks will not lift load?
If your HEIN-WERNER AUTOMOTIVE Jacks won't lift the load, it might be due to a couple of reasons. First, check that the release valve is completely and tightly closed. If it is, the jack might be overloaded. If so, you'll need to address the overload condition.
Why HEIN-WERNER AUTOMOTIVE HW93642 bleeds off after lift?
If your HEIN-WERNER AUTOMOTIVE Jacks bleeds off after lift, it could be due to a hydraulic unit malfunction. Stop using the jack and contact Hein-Werner Technical Service.
What to do if HEIN-WERNER AUTOMOTIVE Jacks will not lower after unloading?
If your HEIN-WERNER AUTOMOTIVE Jacks won't lower after unloading, here are a few things to check: * The reservoir might be overfilled. If so, drain the fluid to the correct level. * The linkages might be binding. Try cleaning and lubricating the moving parts. * The fluid level might be low. Make sure the fluid level is correct.
General| Brand | HEIN-WERNER AUTOMOTIVE |
|---|---|
| Model | HW93642 |
| Category | Jacks |
| Language | English |
Overview of Hein-Werner Hydraulic Service Jacks and their purpose.
Technical details including model, capacity, min/max height, and jack size.
Study, understand, and follow all printed materials provided with/on this product.
Precautions to avoid crushing and related injuries during operation.
Steps to prepare the jack for use, including handle, valve, and fluid checks.
Instructions for lifting a load safely with the hydraulic jack.
Steps for safely lowering a load with the hydraulic jack.
Procedures for adding and changing hydraulic fluid in the jack.
Guidelines for lubricating and cleaning jack components.
Identifies common jack problems and their corrective actions.
Illustrated breakdown and list of replacement parts for the service jacks.
