www.heinner.com 65W, 50Hz, 220-240V
7
Light on, but motor does
not work
Select a fan switch position
Light does not work, motor
does not work
Power cord loose or
disconnected
Refit cord to power outlet.
Switch power outlet on.
One-way valve and the air
ventilation entrance are not
tightly sealed
Take down the one-way valve
and seal with sealant.
Leakage from the connection of
U-shaped section and cover
Take U-shaped section down and
seal.
Replace globes as per this
instruction.
The distance between the cooker
hood and the gas top is too far
Refit the cooker hood to the
correct distance.
The fixing screw not tight enough
Tighten the hanging screw and
make it horizontal
NOTE: Any electrical repairs to this appliance must conform to your local, state and federal
laws. Please contact the service centre if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when opening the unit.
Push button
1. Push stop button, and the motor will stop.
2. Push the low button, and the motor runs at low speed.
3. Push the middle button, and the motor runs at mid speed.
4. Push the high button, and the motor runs at high speed.
To Next Page
Loading...
Need help?
General