www.heinner.com 800W, 50Hz, 230V
17
7. After the desired coffee has been obtained, you should turn the steam knob to
position. The indicator goes out and the coffee maker stops working. Your coffee is ready
now. Then remove the carafe and turn the steam control knob to
position to
release the residual steam in the tank.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you need tp
manually operate it sometimes!
8. Before removing the steel mesh or opening the tank cover, make sure that the pressure
in the tank shall be released. The method is to turn the steam knob to the
position firstly, the steam in the tank will eject from the frothing device. After the
pressure has been released, and the steel mesh has cooled down, you can remove the
steel mesh or open the tank cover.
9. After finishing making the coffee, you can take the metal funnel out by turning it
clockwise, and then pour the coffee residue out with the steel mesh pressed by press
bar. Let them cool down completely, then rinse under running water (when assembling
the steel mesh again, you shall turn over the press bar to the original position).
To Next Page
Loading...
