www.heinner.com 1050W, 50-60Hz, 220-240V
25
3. According to the program of pre-heating, put the metal funnel (no coffee
powder in it) and carafe (jug) in place. Brew water per “PRE-HEATING”.
4. Press down the ON/OFF button to the lower position which is the “ ”
position, the power indicator (orange) will be illuminated, you should press the
pump control button to the lower position which is the position, make
sure the coffee/steam button is on the higher position which is the
position, when there is water flowing out and close the pump by pressing the
pump control button again to the “
” position, and wait for a moment, the
coffee maker begins to be heated.
5. When the ready indicator (green) illuminate, it shows the heating is finish.
Pressing down the pump control button to the lower position which is the
“ ” position and make make two cups coffee (about 2Oz). Then close the
pump and wait for 5s.
6. Press down the coffee/steam button to the lower position which is the
position, waiting for until the green indicator is illuminated. Make steam for
2min, then turn the steam control knob to the minimum position to stop
making steam. Press and release the ON/OFF to the higher position which is
the “
” position to stop the unit immediately, make the descalers deposit in
the unit at least 15 minutes.
7. Restart the unit and repeat the steps of 4-6 at least 3 times.
8. Then pressing and release the coffee/steam button to the higher position
which is the position, when the green lamp is illuminated, press down the
pump control button to the lower position which is the “ ” position to brew
until no descaler is left.
9. Then brewing coffee (no coffee powder) with tap water in the MAX level,
repeat the steps of 4-6 for 3 times (it is not necessary to wait 15 minutes in
step of 6), then brewing until no water is left in the tank.
10. Repeat the step of 9 at least 3 times to make sure the piping is cleanly.
To Next Page
Loading...
