To reduce the risk of fire, explosion, electric shock, or injury when using your ice maker,
follow these improtant safety instructions:
1. Before using check that the voltage power corresponds to the one shown on the
appliance nameplate.
2. Do not remove any safety, warning, or product information labels from your ice
maker.
3. Plug the ice maker into an exclusive grounded 3-prong outlet. No other appliance
should be plugged into the same outlet. Be sure that the plug is fully inserted into the
receptacle.
4. This appliance must be grounded. It is equipped with a 3-wire cord having a
grounding plug. The plug must be plugged into an outlet that is properly installed and
grounded.
5. Avoid the use of an extension cord because it may overheat and cause a risk of fire.
However, if it is necessary to use an extension cord:
1) Use only 3-wire extension cords with 3-blade grounding plug.
2) The marked rating of an extension cord must be equal to or greater than the rating
of this appliance.
3) It should be positioned such that it does not drape over the counter or tabletop
where it can be pulled on by children intentionally.
6. Do not operate any appliance with a damage cord or plug or after the appliance
malfunction or has been damaged in any manner. Return the appliance to the nearest
authorized service facility for examination, repair or adjustment.
7. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
8. Do not let cord hang over edge of table or counter.
9. Do not place on or near a hot gas or electric burner, or in a heated oven.
10. Place power cord in such a way it cannot be pulled on by children or cause a
tripping hazard.
11. Place power cord in such a way that it is not in contact with hot surfaces.
12. The use of attachment not recommended or sold by manufacturer may cause fire,
electric shock or injury.
13. Do not touch the evaporator when using the ice maker or making ice to avoid being
suffer from frostbite.
14. Do not immerse any part of the product in water.
15. To disconnect, turn any control to “OFF”, then remove plug from wall outlet.
16. Do not plug or unplug product with wet hands.
17. Unplug the product before cleaning, maintaining and when not in use.
18. Do not use with water that is microbiologically unsafe or of unknown quality.
To Next Page
Loading...
