www.heinner.com 120W, 220-240V, 50Hz
1. Please note, if a power failure occurs due to disconnection of the power cord, or
the power button has been pushed off during an ice making cycle, small ice chips may
formed and lodge in the automatic shovel causing it to jam. If this occurs, the ice chips
may be removed by disconnecting the power cord and gently pushing the shovel to
the rear of the cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove the
ice to ice basket. If not, please push the ice shovel gently by finger, then press POWER
button to restart.
The compressor works
abnormally with a Buzzing
Noise
The voltage is lower than
recommended
The voltage is lower than
recommended
The voltage is lower than
recommended
1.There is no water
2.The pump is full of air
1.There is no water
2.The pump is full of air
Indicator lights on display
are not on
Replace fuse / Turn power
on
The Ice made is too large
and with pieces sticking
together.
1.water temperature is
too low
2.Ice of previous cycles
left in the water tray
1.Select small size
2.Take out the ice under
the standby state
All indicators twinkle
simultaneously
Water tray is blocked by
ice cube
Unplug the power to take
out the ice which blocking
the tray, then plug the
power and press the
POWER button, the
machine will restart 3mins
later.
To Next Page
Loading...
