Heinner HMSF-9BK - Cleaning and Maintenance

www.heinner.com 19W, 50Hz, 220-240V
23
VIII. CLEANING AND MAINTENANCE
MAINTENANCE INSTRUCTION
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to qualified
service personnel if service is needed.
1. Before cleaning and assembling, fan must be unplugged.
2. To ensure adequate air circulation to the motor, keep vents at the rear of the motor
free of dust. Do not disassemble the fan to remove dust.
3. Please wipe the exterior parts with a soft cloth soaking a mild detergent.
4. Do not use any abrasive detergent or solvents to avoid scratching the surface. Do not
use any of the following as a cleaner: gasoline, thinner.
5. Do not allow water or any other liquid into the motor housing or interior parts.
CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with a soft cloth moisten with mild soap. Thoroughly
remove soap film with dry cloth.
Functions
Operation Instructions
Startup/Standby.
Start up or shut down oscillating and air blowing.
Switch the wind type.
“- , +”
Set the wind speed or time.
Start up or shut down the mode of the wind changing with the
temperature.
It can only be shut down at the set time when it is started up, and
the machine can only be started up after reservation in standby
state;
After clicking , the time can be set by pressing or "+ and -"
(cycle: 0-1-2 -... 8-0h), and the timing will be determined after the
indicator has been flashed for 3 times.
If the set time displays 0, meaning the timing / reservation is
cancelled.