32
Battery Charge
Parking on charging area
Open the battery cover
Open the battery water gate
Pull out the main electrical power plug
Connect the charger with main electrical power
plug
Note: Charge the battery as soon as possible.
Do not keep battery on uncharged or electrical
power shortage condition.
Battery Inspection
Inspect whether the battery shell has crack,
electrode plate is out, electrolyte leaks out.
Open the battery water gate and inspect the
liquid level. Liquid level should be higher than
protection board 15-20mm. If the electrolyte
height is not enough, add distilled water to
gate bottom.
Clear the oxide on electrode plate and paste the
non-acid grease regular, and tighten the
electrode clip.
Measure the electrolyte density with densimeter.
The value should be 1.24-1.28.
Note: If the battery discharge capacity is more
than rated value 80%, the work life will
decrease.
Adjusting the seat
Rotate the pole inwards. Slid the seat
to suitable position for the driver.
Then rotate the pole outwards and let
it locked in the nearest notch.
Replace Battery
Especially note that the replaced battery
should has same dimension and weight as
standard equipped one.
Please use crane and insulation line with
enough energy.
The process for replacing battery:
1. Ensure that the tractor park well.
2. Switch off the electric power and take
out the key.
3. Open the battery cover.
4. Pull out the main electrical power plug.
5. Dismantle the main electrical power
wiring.
6. Loosen the fixed bolt of battery box.
7. Suspend the battery with crane.
8. Put the whole battery aside.
9. Lay back the charged well or new battery
as contrary sequence.
Please contact with local Heli sales
company, deputy or Heli engineers if
have any trouble.
To Next Page
Loading...