33
Steering
Note: Make the running way suitable with load
condition, especially in safe work surround and
with load.
Starting
Plug into the main electrical power plug.
Insert key into keyhole, and rotate it clockwise.
Instrument panel is electrified and indicates
signals.
Loosen the parking arrester. Note the parking brake
indicator light.
Going forward
Move direction switch forward with hand, and the
forward indicator light on panel is on. Slowly step
on accelerator pedal, and the depth of stepping
pedal decides the traction speed.
Note: Step on the pedal rapidly cannot increase the
speed immediately, because the maximum accelerator
is controlled automatically and pre-set.
Going backward
Move direction switch backward with hand, the
reverse indicator light on panel is on, and the
reverse buzzer sounds. Slowly step on accelerator
pedal, and the depth of stepping pedal decides the
traction speed.
Note: Step on the pedal rapidly cannot increase the
speed immediately, because the maximum accelerator
is controlled automatically and pre-set.
Note
Because adopting the operation sequence
protection function, the driver should
operate following the indications above.
If first step on accelerator pedal, then
move direction switch with hand, the
traction cannot move. Also the instrument
panel trouble indicator will alarm with
“
05”
code. It does not mean that there is
trouble with traction itself.
Also should first loosen the direction
switch when shifting to forward or
backward switch
If leaving the tractor after parking, the
driver should switch off key switch, pull
out the key, and plug out the main
electrical power plug.
Braking
This tractor has the function of magnetic
brake. It is optional. Loosen the
accelerator pedal; the tractor will stop
slowly because of the magnetic brake.
Running-brake
Loosen the accelerator pedal.
Step on the brake pedal.
Note: Stepping on the brake pedal will
hydraulic brake on the motor output axis
end through the brake general pump.
To Next Page
Loading...