Need help?Do you have a question about the Heliotrope PV RV-45D and is the answer not in the manual?
General| Brand | Heliotrope PV |
|---|---|
| Model | RV-45D |
| Category | Controller |
| Language | English |
Maintains batteries at highest state-of-charge with least water consumption.
Set from 13.2 VDC to 14.6VDC in 0.2 volt increments.
Options for Flooded Lead-Acid, AGM, or Gel batteries.
Adjusts charge setpoint based on battery temperature.
Charges both Engine and House battery banks from solar panels.
Uses DIP switches to select SOC (state-of-charge) and MODE.
Selects battery state-of-charge voltage using DIP switches #1, #2, #3.
Shows recommended settings and DIP switch positions for Flooded Lead-Acid batteries.
Shows recommended settings and DIP switch positions for Sealed Lead-Acid batteries.
DIP switch #4 activates or deactivates the MODE function (Auto-Equalization/Float).
Controls the temperature compensation sensor jumper on the circuit board.
Describes setup for Flooded Lead-Acid batteries using "EQ" mode.
Describes setup for Sealed Lead-Acid batteries using "FL" mode.
Explains the charge controller's operation during the equalization cycle.
Explains the charge controller's operation during the automatic float mode.
Explains operation when the MODE DIP switch is set to OFF.
To Next Page