BEFORE FIRST USE
Unwind all the power cord, and remove all package material. Connect the heater to a power source of the
same voltage, frequency and rating as indicated on the product rating plate before switching the unit on.
FITTING ELECTRIC BLANKETS
Note: Ensure that the electric blanket is one to suit your mattress. Your electric blanket must be laid on a
firm and un-adjustable mattress. The blanket should be laid flat from shoulder to feet when sleeping. If
using a mattress protector, this goes over the electric blanket.
Important:
- Place the blanket onto the mattress with the bed
controller connection/s at the HEAD END of the bed.
Note: Electric blankets MUST NOT be used on top
of the user (as with a normal blanket); instead they
must be firmly secured to the mattress.
- Fit the side skirts around the edges of the mattress
then use the elastic skirt to ensure that the blanket
fits snugly around the sides and underneath the
mattress.
- Spread the skirt around the mattress edge ensuring
even tension and making sure the blanket is placed
evenly over the mattress then ensure that the blanket
is flat and crease free.
Note: Care should also be taken if you are using continental quilt because heat will build up more quickly
than with other bed coverings. A short period may only be needed to reach maximum temperature
depending on the insulation density of your quilt. This also applies if using additional bed blankets.
- The electric blanket should not be tucked in at the sides.
- Make your bed in the usual manner.
- After the blanket is secure and fitted correctly, plug the controller/s into the wall power socket and
turn on.
Note: Do not plug into a power board, double adaptor or anything similar. The power plug must be
inserted directly into the wall power socket.
To Next Page
Loading...