HELLER HECS12 - Speed, Swing, Timer, and Cool Functions

CAUTION: To avoid of electric shock, you must always switch off and unplug the fan before cleaning.
C. SWING:
• Press the button if you want the vertical louvers to swing from left to right.
• Press it again to stop the vertical louvres from swinging.
Note: The Horizontal louvres can be manually adjusted to direct the air higher or lower.
D. SPEED:
• By default, when the unit is turned “On”, it starts at “Low” Speed.
• Each press of the “SPEED” button advances the Speed setting as indicated by the lights above the
“SPEED” button. Continue to press the button to cycle around.
• Press the “ON/OFF” button to turn the appliance off.
E. TIMER:
• Use this power-saving feature if you want the appliance to turn off automatically.
• To select the “OFF” time, press the “TIMER” button once. It will advance to 0.5H as indicated by
the indicator lights above the “TIMER” button. The cooler will turn off after approximately 0.5
hours.
• Each consecutive press will advance the timer at 0.5H increments until it reaches a maximum
time of 7.5H.
The time set will be indicated by the sum of the lights which are illuminated. i.e. if the 0.5H + 2H
+ 4H lights are illuminated, this adds up to be 6.5 hours. The cooler will turn off after
approximately 6.5 hours.
• To turn the Timer “OFF”, or reset to a new time, continue to press the “TIMER” button until it
cycles back around where no time lights are illuminated.
• Press the “ON/OFF” button to turn the appliance off.
F. COOL MODE FUNCTION:
• Press the “COOL” button if you want to have cooler wind blowing from the air cooler. (Please refer to
section “Guide to Evaporative Coolers”).
This activates the cooling water mechanism inside the appliance causing the air to be cooler.
The indicator light above the button will be illuminated when this feature is on.
• Press the “COOL” button again to turn this function off.
• Press the “ON/OFF” button to turn the appliance off.
•
NOTE: All of the above can be operated via the remote controller.
CARE & CLEANING
To ensure effective humidifying and filtering, it is recommended that the filtering system be cleaned once
every 1-2 months.
NOTE: If the power cord set of this appliance becomes damaged, discontinue use. Repairs should be
undertaken only by a qualified technician.