PARTS & FEATURES
1. Front Guard
2. Fan Blades
3. Back Guard
4. Handle
5. Speed Control Switch (0,1,2)
6. Bolt/ Wing Knob
7. Base
8. Motor Housing
BEFORE FIRST USE
Before use, remove all packaging and inspect the appliance for any damage. If there appears to be any
damage, please take the unit back to place of purchase for a replacement.
ASSEMBLY INSTRUCTIONS
1. Loosen the rear guard mounting nut from the motor housing.
2. Fit the rear guard onto the motor housing and fasten by turning the guard mounting nut tightly,
but do not over tighten.
3. Fit the blade onto the motor shaft.
4. Connect the front guard to the rear guard and clip them together with the clips provided.
5. Both guards must be secured with the screws provided.
To Next Page
Loading...
Need help?
General
