18
6. Slide the chain onto the chain
wheel as shown. Then slide the rear
wheel axle into the slots on the rear
end of the frame. (Replace with a new
chain, new rear brake or a new rear
wheel at this time.)
7. Press the chain tensioner and
maneuver the chain onto the small
sprocket on the motor at front.
Note: The chain tensioner must align
and fit against the chain to ensure
that the chain will not come loose
during usage.
8. Refer to Steps 2-4 and:
A. Tighten the brake housing anchor;
B. Tighten the axle locknuts on both
sides with 15mm wrenches securely;
C. Adjust the brake cable and tighten
the brake cable anchor securely;
To Next Page
Loading...