19
9. Re-attach the chain guard. Test ride
and readjust as needed.
Chain Tensioner
Replacement:
Note: Use a Phillips screwdriver to
remove the 4 bolts from the chain
guard.
1. Lift the chain tensioner arm up.
2. Use the Phillips screwdriver to
loosen (counter-clockwise) the bolt
on the chain tensioner.
3. Pull out the worn chain tensioner
and replace it with a new one.
4. Repeat the steps above in reverse
and securely tighten all bolts
before finishing.
Note hardware sequence as shown above:
Left Side
D- Rear brake cover
B- Washer
A- 15mm locknut
Middle
E– Rear wheel set
(with chain wheel on)
Right Side (Throttle Side)
C- (Long) spacer
B- Washer
A- 15mm locknut
To Next Page
Loading...