IMPORTANT:
This unit has a polarized AC plug with one wide blade and one
narrow blade. This plug will only fit into a matching polarized
AC outlet. This is a safety feature to reduce the possibility of
electric shock. If this plug will not fit in your AC outlet, you
probably have an outdated non-polarized outlet. You should
have your outdated outlet changed by a qualified, licensed
electrician. Do not file the wide blade on the plug, or use an
adapter to make the plug fit onto your outlet. This defeats the
safety feature and could expose you to electric shock.
RADIO OPERATION
1. Slide the FUNCTION SELECTOR to “RADIO”. The POWER INDICATOR will light.
2. Rotate the TUNING CONTROL to your desired radio station according to the DIAL SCALE.
3. Rotate the VOLUME CONTROL to adjust to the desired output level.
4. To turn off the radio, slide the FUNCTION SWITCH to “OFF”.
TIPS FOR BEST RECEPTION
AM – The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change
the position of unit until the internal antenna picks up the strongest signal.
FM – If a stereo broadcast program is being received, the FM STEREO INDCATOR will light.
During FM reception, always keep the TELESCOPIC ANTENNA fully extended for best
performance. However, if FM reception is weak, try repositioning the unit near an open
window until you get the best reception.
CD OPERATION
THIS UNIT NOT ONLY PLAYS COMMERCIAL COMPACT DISCS BUT ALSO SELF-COMPILED
CD-RW DISCS.
• Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance is not guaranteed.
• Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions
such as PC performance, writing software, media properties etc.
• Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.
PLAY MODE
1. Slide the FUNCTION SELECTOR to the “CD/AUX” position. The POWER INDICATOR will
light.
2. Open the CD COMPARTMENT COVER, the LED DISPLAY will show “00”. Load a CD with
the label side facing upward and then close it.
3. A few seconds later the total number of tracks on the CD will appear on the LED display.
4. Press the PLAY/PAUSE BUTTON to start playing the CD from the first track. The
PLAY/PAUSE INDICATOR will light steadily.
5. Adjust the volume control to the desired volume level.
6. While playing, press the PLAY/PAUSE BUTTON once to pause, the PLAY/PAUSE
INDICATOR will flash. Press PLAY/PAUSE BUTTON again to resume playing.
To Next Page
Loading...
Need help?
General
