8
AM - The AM bar antenna is inside the cabinet. If AM reception is weak, change
the position of cabinet until the internal antenna picks up the strongest signal.
ANTENNA INFORMATION
FM - The FM antenna is built in to the AC power cord. If FM reception is weak try
varying the position and direction of the power cord until you find the strongest
signal.
1. Slide the ALARM selector to ON and select the band, station, and volume level
that you wish to hear when the alarm comes 'On', then slide the ALARM selector
to AUTO position
2. Reconfirm the wake up time settings by pressing the ALARM/RESET button.
3. At the selected wake up the time radio will turn 'On'. It will play for about two
hours and then shut off automatically.
4. To stop the radio sooner, press ALARM/RESET button. The radio will stop but
the alarm remains set and will turn the radio on again at the same time on the
following day.
5. If you do not want the alarm to turn the radio on the following day, set the
ALARM selector to the 'OFF' position.
WAKE TO RADIO
1. Set the BAND selector to the desired band, AM or FM.
2. Set the VOLUME control to a low setting.
3. Slide the ALARM switch to the ON position.
4. Select your desired station with the TUNING control.
5. Adjust the VOLUME control to the desired setting.
6. When you are finished listening, slide the ALARM selector to OFF position to
turn the radio 'Off' .
LISTENING TO THE RADIO
To Next Page
Loading...
