7
iPod shuffle) and listen through the speaker.
1. Switch on the speaker by sliding the POWER switch to “ON”. The Power LED should light
and remain on.
2. Press the “AUX” button on the Remote Control once.
3. Plug one end of the included audio cable into the AUX IN Jack on back of speaker and the
other end of the cable into the Line-out Jack or Headphone Jack of your external audio
device.
4. Turn on the external audio device.
5. Adjust the volume of the speaker by touching its left or right ear or pressing the “
”/ “ ”
buttons on the Remote Control. Operate all other functions from the auxiliary device itself.
Note:
(1) If you connected the LINE OUT Jack of your external device then you only need to adjust
the volume of the speaker using the Remote Control or touching its left or right ear. If you
connected the Headphone Jack of your external device then you may need to adjust both
the volume control of your external device and the volume level of the speaker to find the
most desirable volume setting.
(2) Switch off the speaker by sliding the POWER switch to “OFF” when you have finished
listening. The Power/Status indicator on the speaker will go off. Don't forget to switch off
the power of your external device as well.
CARE AND MAINTENANCE
1. Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
2. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
3. In case of malfunction, unplug the unit from the electrical power outlet immediately.
CLEANING THE UNIT
To prevent fire or shock hazard, disconnect the AC adapter of your unit from the AC
power source when cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture,
Use caution when cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or
polish sprays on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths
or polishes as these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.
To Next Page
Loading...
Need help?
General
