EasyManua.ls Logo

Helmer UltraCW II - User Manual

Helmer UltraCW II
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Automatic Cell Washing System Operation Manual
®
I
I
360386/D
Question and Answer IconNeed help?

Do you have a question about the Helmer UltraCW II and is the answer not in the manual?

Summary

About This Manual

Safety Precautions and Symbols

Explains safety symbols used in the manual and on the unit.

General Recommendations

Avoiding Injury

Provides critical safety advice to prevent operator injury.

Unpacking

Unpacking Guidelines

Provides steps and precautions for safely unpacking the cell washer.

Emergency Release

Explains how to use the emergency release to open the lid.

Transport Bolts

Details the removal and installation of transport bolts.

Installation and Configuration

Location and Placement

Specifies requirements for the unit's location and environment.

Setup

Outlines the steps for connecting the unit and its components.

Initial Start-Up

Guides the user through the first power-on and initialization process.

Rotor Installation and Setup

Install Rotor

Details how to install the rotor onto the shaft.

Install Tube Inserts

Explains how to insert tube holders into the rotor.

Remove Tube Inserts

Details how to remove tube inserts from the rotor.

Rotor Type Selection

Explains how to select the correct rotor type in the system settings.

Rotor Balancing and Calibration

Balance Rotor

Describes the procedure for balancing the rotor before running programs.

Flow Calibration

Guides the user through calibrating saline dispensing volume.

Programming Processes

Spin Process

Explains the Spin process for separating particles and creating cell buttons.

Fill Process

Details the Fill process for adding saline solution to tubes.

Down Process

Explains the Down process to force clinging drops to tube bottoms.

Agitation Process

Describes the Agitation process to break apart cell buttons.

Advanced Programming Processes

Decant Process

Explains the Decant process for waste solution expulsion.

Loop Process

Details the Loop process for repeating program steps.

Check Process

Describes the Check process for pausing the program for inspection.

Operation: Pre-Installed Programs

Pre-Installed User Programs

Lists and describes the system's pre-installed washing programs.

Program Management

Stop;Check Program

Explains how to stop or pause an ongoing program for checks.

Custom Program Creation

Creating Custom Programs

Guides users on creating and saving custom washing programs.

Product Specifications

Operating Standards

Lists environmental conditions for optimal unit operation.

Preventive Maintenance

Maintenance Schedule

Provides a schedule for daily, weekly, monthly, and annual maintenance tasks.

Compliance Information

Regulatory Compliance

States product certifications and sound level information.

WEEE Compliance

Explains disposal guidelines for the product under WEEE directive.

Appendix A: Error Codes

Motor and Injection System Errors

Lists motor and injection system error codes and their causes.

Appendix A: Error Codes Continued

Lid and System Errors

Lists lid and system error codes and their causes.

Miscellaneous Errors

Lists miscellaneous error codes and their potential causes.

Appendix B: Parts Identification

Component Labels

Identifies various components of the cell washing system with labels.

Helmer UltraCW II Specifications

General IconGeneral
BrandHelmer
ModelUltraCW II
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals