Helping Hand Symmetrikit Poser

To Next Page

Fig.1

Fig.2

Fig.3

Fig.4

Label

Fig.5

Fig.6

Anti-Spasm loop slings

1. Ensure the label is on the outside of the sling

and feed down the back of the client. Push the

top of the commode apeture as far down under

the client as possible. Check the shoulder straps

are square with the clients shoulders, fig.1.

2. Lift the clients’ legs and feed the leg strap

under then up through between their legs,

leaving the hip straps on the outside. Check that

the sling is not twisted under the leg. Repeat for

the other leg as fig.2.

3. Cross the leg straps and attach to the front

hooks of the hanger frame on the longest loop.

Attach the hip straps also to the front hooks of the

hanger frame on the longest loop. Attach the

shoulder straps to the rear hooks of the hanger

frame on the shortest loop for an upright posture

illustrated in fig.3.

4. Raise the hoist and ensure that the client

is secure and comfortable. Using the shorter

loops on the legs and hips with the longer

loops on the shoulders, achieves a more

reclined position, fig.4.

5. To establish firm head support connect the head

rest clips as fig.5 and adjust for the clients’ comfort.

6. Finally connect the chest

belt fig.6, again adjust for the

clients confort and tidy the

strap ends.

The client should now be safely and comfortably supported and restrained.

WARNING: Only use the loop attachments on loop hanger bars.

CAUTION: Before every lift visually inspect the sling’s structural integrity.

If there is any sign of damaged fabric or stitching do not use the sling.

RX10580_3

Symmetrikit is a division of The Helping Hand Company Limited,

Bromyard Road, Ledbury, Herefordshire, HR8 1NS

Tel: 01531 635388 Fax: 01531 638059

sales@symmetrikit.com www.symmetrikit.com

Need help?

Do you have a question about the Helping Hand Symmetrikit Poser and is the answer not in the manual?

Summary

Poser Anti-Spasm Loop Slings Usage

Sling Preparation and Label Placement

Ensure the label is on the outside, feed down the client's back, and position the commode aperture.

Leg Strap Positioning

Lift client's legs, feed leg strap under, ensuring hip straps remain outside and no twists occur.

Hanger Frame Attachment

Attach leg/hip straps to front hooks (longest loop) and shoulder straps to rear hooks (shortest loop).

Hoist Operation and Reclined Position

Raise hoist, verify security and comfort. Use shorter loops for a more reclined posture.

Head Support Connection

Connect the head rest clips and adjust them to ensure the client's comfort.

Chest Belt and Final Adjustments

Connect the chest belt, adjust for client comfort, and tidy any excess strap ends.

Sling Inspection Information and Safety

General Inspection Guidelines

Visually inspect sling integrity before each lift. Do not use if fabric or stitching is damaged.

Stitching Integrity

Carefully examine all stitching. Remove from service if any doubt exists regarding its condition.

Material Degradation Checks

Check clips, retaining straps, and body material for nicks, cuts, fatigue, or discolouration.

Service Life Assessment

Assess service life by checking sling body, binding, and labels for fading indicating extensive use.

Inspection Procedures

Lay sling flat, examine base material and stitching. Minor holes in non-critical areas may be acceptable.

Periodic Re-assessment

Implement bi-annual re-assessment and inspection. Maintain full records for all slings.