EN
Check for your cookwares for Induction
The cookware used with Induction cookers should have flat bottom for good contact
with the surface of the cooking zone. Please check the flatness by rotating a ruler
across the bottom of the cookware.
bottom pan curved or
Operating the appliance
Put the plug in the socket
Set the pan of your choice on the cooking surface, bearing the above mentioned
instructions in mind
Note! Do not leave your pan on the appliance while empty as this may lead to damage
to your pan
Switch the appliance on by pressing the "ON/OFF key"
and either the temperature
key or power key to activate the appliance
If your pan is suitable for induction and has a bottom diameter of 12cm, at minimum,
the appliance will go into operation.
If you have pressed the power key , the appliance will enter in capacity mode
operation and you will recognize this from the fact that the fan will go on and the
display will show a capacity position of "100".
To Next Page
Loading...
