Preparations before using for the first time
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and a
soft cloth.
• Place the appliance on a level and steady surface,
unless mentioned otherwise.
• Make sure there is enough clearance around the
appliance for ventilation purposes.
• Position the appliance in such a way that the plug
is accessible at all times.
• Check that the ice basket and scoop are included.
If any parts are missing, contact your supplier.
• Clean the inside of the appliance with lukewarm
water and a soft cloth.
• Clean the ice basket.
• Do not place the ice maker in direct sunlight or
close to a heat source.
• Do not use the ice maker for at least 24 hours af-
ter it has been transported and moved from one
place to another.
Instructions for use
• Open the lid, remove the basket and fill the reser-
voir with water. Do not fill beyond the level indica-
tor. Make sure the basket is above water.
• Press the “Power” button to start the process.
• Select the size of the ice cubes by pressing the
“Select” button. If the room temperature is below
15°C, select “Small” or “Medium” ice cubes to
prevent the ice cubes from melting together.
• The entire process of making ice cubes takes be-
tween 6 and 12.
• Check the water level regularly. When the water
level is too low the appliance will stop automati-
cally and the “Water” indicator will light up. Press
the “Power” button, fill the water reservoir up to
the level indicator and press the “Power” button
again.
• Let the appliance rest for 5 minutes to let the
coolant in the compressor settle before restarting
the appliance.
• The ice maker stops automatically when the bas-
ket is full.
• Put fresh water in the reservoir every day.
• When not in use, empty the reservoir via the drain
tap.
• Beware: Never tip the appliance more than 45°
and do not turn the appliance upside down. This
will damage the appliance beyond repair.
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water or
any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects.
Do not use petrol or solvents! Clean with a damp
cloth and detergent if necessary. Do not use abra-
sive materials.
• There is a filter in the water reservoir. This filter
should be cleaned frequently. Remove the filter
from the water reservoir and rinse it thorough-
ly with lukewarm water. Detergents may also be
used. Rinse the filter afterwards with clean water
so that no residue of detergents remain.
EN
To Next Page
Loading...
