13
NL
13
EN
Ice Making Parts Cleaning
During the using, periodically to clean these main
system of your ice-maker.
1. Repeat above step to clean the water tank and
other inner parts of the unit.
2. Clean the water dividing pipe on the evaporator
extra, uninstall this part and clean each little hole
displayed in the following illustration, make sure
each hole is not clogged, then install back to the
original location.
3. When there are ice cubes on the surface of the
evaporator, but they can’t fall, don’t remove it by
force; just press the “ ” button for more than 5
seconds, the unit will enter the ice melting pro-
cess. After some while the big ice-cubes will fall
down. Turn off the unit and unplug the power cord
to clean the surface of the evaporator.
4. For the water tank and ice-full detecting plate
Also the water tank and the ice-full detecting plate
is very important to keep your ice cube hygienic. Put
mixture of neutral cleaner & water into a clean wa-
ter jet, then spray to all the inner surface of tank &
the ice detecting plate. Wipe these surfaces as far as
possible with a clean cloth. And then, spray the sur-
faces with clean water, wiping with a dry clean cloth.
Then drain out the cleaned water in the water tank
by pulling out the Water drain pipe of the water tank
indicating (H in illustration). When all of the cleaned
water has been drained out, reinstall back the water
drain pipe of the water tank.
Suggestion: After cleaning the interior parts dis-
card the first batch of ice.
Descaling the machine
Minerals that are removed from water during the
freezing cycle will eventually form a hard scaly de-
posit in the water system. Cleaning the system reg-
ularly helps remove the mineral scale buildup. How
often you need to clean the system depends upon
how hard your water is. With hard water of 4 to 5
grains/liter, you may need to clean the system as of-
ten as every 6 months.
1. Turn off the ice maker. Keep the ice maker con-
nect to the water supply and drainpipe. But shut
off the water faucet of main water supply.
2. Open the door and scoop out all of the ice cubes.
Either discard them or save them in an ice chest
or cooler.
3. Making the cleaning solution. Please mix the
Nu-Calgon Nickle Safe Ice Machine Cleaner with
water to make the cleaning solution.
WARNING: Wear rubber gloves and safety goggles
when handling Ice Machine Cleaner
Use a plastic or stainless container with more than
4 liters capacity, mix 300 ml Nu-Calgon Nickle Safe
Ice-machine Cleaner with 2.8 liters warm water
about 50-60ºC, Then divide them for 2 shares equal-
ly in 2 cups. It is better to keep the temperature of
each cup of the cleaning solution.
4. Check to be sure that the water drain pipe of the
water tank has been installed properly in the slot
of the tank wall. Then Pour one cup of Nickel-Safe
Little holes of water dividing pipe
Water
dividing pipe
Then move out
right toward
Pull up
first
Evaporator
Water tank
Ice-full detecting plate
To Next Page
Loading...
