14
NL
14
EN
Ice Maker Cleaning Solution into the water tank.
Wait about for 5 minutes.
5. Turn on the power to the ice maker, then press
“
” button on control panel for more than 5 sec-
onds, to enter the self-Cleaning program. During
this process, the “Clean” light will always be on
during this period, and the digit window will indi-
cate the time left.
6. After self-cleaning program, pull out the drain
pipe of the water tank, drain the cleaning solution
down to the lower ice storage bin. Shake the unit
slightly to drain out all of the cleaning solution
completely. Then install back the drain pipe to the
slot of the water tank.
7. Repeat steps 4--6 to clean the ice making assem-
bly system again.
WARNING: The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based
cleaner products. Use rubber gloves to protect
hands. Carefully read the material safety instruc-
tions on the container of the ice machine cleaner.
8. Open the water faucet of the main water supply,
let the water flow in the unit. Again press the“ ”
button on control panel for more than 5 seconds,
to enter the self-Cleaning program. Through this
process, It will rinse the water dividing pipe, evap-
orator, water pump, silicone pipe, and water tank,
etc..
9. After one self-cleaning program complete, then
pull out the drain pipe of the water tank, drain the
cleaning solution down to the lower ice storage
bin, also shake the unit slightly to drain out all of
the water completely. Then install back the drain
pipe to the water tank slot tightly.
10. Repeat the step 8-9 again 2 times.
11. Following the above program to clean the ice
storage bin .
12. Discard the first batch of ice cube.
Cleaning Suggestion
1. DAILY CLEANING
The ice shovel, door and the water dividing pipe
should be cleaned by yourself per each day. At the
end of every day, rinse the ice shovel and wipe the
both sides of the door with a clean cloth.
2. SEMI-MONTHLY CLEANING
The ice shovel, ice bin, water tank, the ice-full de-
tecting plate and the surface of the evaporator are
to be cleaned by yourself semi-monthly according
to interior cleaning program.
3. SEMI-ANNUAL CLEANING
All the components & surfaces exposed to wa-
ter or ice cubes, like ice storage bin, water tank,
door, evaporator, water pump, silicone tube, wa-
ter dividing pipe, etc. should be cleaned by Using
Nu-Calgon Nickle Safe Ice-machine Cleaner per
each 6 months.
To Next Page
Loading...
