EasyManua.ls Logo

Hendi 271575 - Important safety; Specifications; Dimensions;Connections

Hendi 271575
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
EN
Important safety
This ice-maker must be properly installed in ac-
cordance with the installation instructions before
it is used.
We do not recommend the use of extension cord as
it may overheat and cause a risk of fire. If you must
use an extension cord, use 1.5mm2 minimum size
and rated no less than 1875 watts.
Do not tip over the unit which will cause abnormal
noisy and make the ice-cube size abnormal, it may
cause water leakage from the unit.
If the unit is brought in from outside in the winter
season, give it a few hours to warm up to room
temperature before plugging it in.
Do not use other liquid to make the ice-cube other
than water.
Do not clean your ice maker with flammable fluids.
The fumes can create a fire hazard or explosion.
WARNING: Keep ventilation openings, in the appli-
ance enclosure or in the built-in structure, clear
of obstruction.
– WARNING: Do not damage the refrigerant circuit.
WARNING: Do not store explosive substances such
as aerosol cans with a flammable propellant in
this appliance.
WARNING: This appliance is intended to be used in
household and similar applications such as; staff
kitchen areas in shops, offices and other working
environments; catering and similar non-retail ap-
plications.
IMPORTANT:
The wires in this mains lead are colored in accord-
ance with the following code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the color of the wires in the mains lead of the ap-
pliance may not correspond with the colored mark-
ings identifying the terminal in your plug, proceed
as follows:
The wire which is colored green-and-yellow must
be connected to the terminal in the plug which is
marked with the letter E, G or by symbol or colored
green or green-and-yellow.
The wire which is colored blue must be connected
to the terminal which is marked with the letter N.
The wire which is colored brown must be connected
to the terminal which is marked with letter L.
NOTE: Created ice cubes are joined together and
still need to be broken apart before use.
Specifications
1) Dimensions/ Connections
Water Drainage Port
Water Inlet Port

Related product manuals