8
NL
8
EN
Unpacking your ice maker
1. Remove the exterior and interior packaging.
Check if all the accessories, including instruction
manual, ice scoop, white water inlet pipe, 4 ways
to 2 ways water quick connector and the water
draining pipe, etc., are inside or not. If any parts
are missing, please contact our customer service.
2. Remove the tapes for fixing the door and inned
cabinet, ice scoop, etc.. Roughly clean the inner
cabinet & ice scoop with wet clothe.
3. Put the ice maker on a level & flat floor, without
direct sunlight and other sources of heat (i.e.:
stove, furnace, radiator). Maker sure that there is
at least 20cm gap between the air outlet and the
obstacles, and at least 5 cm between Left/Right
side and the wall.
4. Allow 4 hours for the refrigerant fluid to settle be-
fore plugging the ice maker in if the unit maybe
fall upside down during shipping or transporta-
tion.
5. The appliance must be positioned so that the plug
is accessible.
WARNING: Only use drinking water to make ice.
Installation location requirement
a) Keep the proper room temperature and inlet wa-
ter temperature according to above specification
table. Otherwise it will affect the ice making per-
formance.
b) This unit should not be located near any heat
source.
c) The unit should be located on a firm & level foun-
dation at normal counter top height.
d) There must be at least 15 cm clearance at rear
side for connection and 20 cm clearance in front
to open the door and keep good air circulation.
e) Do not put anything on the top of the ice maker.
When installing the ice maker under a counter, fol-
low the recommended spacing dimensions shown
above. Place electrical and water supplies and drain
fixtures in the recommended locations as shown.
Choose a well-ventilated area with temperatures
above 10˚C and below 32˚C. This unit MUST be in-
stalled in an area protected from the elements, such
as wind, rain, water spray or drips.
The ice maker requires a continuous water supply
with pressure 1-8 Bar as required in above specifi-
cation table. The temperature of the water feeding
into the ice maker should be between 5˚C and 25˚C
for proper operation.
Electrical requirement & connections
WARNING: THIS UNIT MUST BE EARTHED.
• Before you move your ice maker into its final lo-
cation, it is important to make sure you have the
proper electrical connection.
• It is recommended that a separate circuit, serving
only your ice maker, be provided. Use receptacles
that cannot be turned off by a switch or pull chain.
If the supply cord or plug to be replaced, it should
be done by a qualified service engineer.
• This appliance requires a standard 220-240 Volt,
50Hz electrical outlet with good grounding means.
Installation clearance top view
(1:10) (mm)
Side view (mm)
To Next Page
Loading...
