EasyManua.ls Logo

Hendi 970362 - Page 6

Hendi 970362
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
EN
Automatic mode
The display shows a highlighted red line at the
bottom next to the “MAN” label – this marks the
manual cycle.
Push the SET/SEAL button shortly – the line
starts flashing.
Using the START/STOP button, other lines are
activated (the second and third line with AUT 1
and AUT 2 label respectively).
As long as the lines are flashing you can change
the mode from manual to one of the two available
automatic modes.
After selecting the desired operation mode of the
appliance, a digit from 1-9 starts flashing. It indi-
cates the vacuum level.
The vacuum level may be increased using the
START/STOP button or decreased using the SET/
SEAL button but only when the digit is flashing.
After setting the vacuum level the digit stops
flashing automatically and disappears. The dis-
play shows a highlighted line (lines) which indi-
cates the operation mode.
In the automatic mode (AUT 1 and AUT 2) press
START/STOP to start the packing appliance.
After removing air from the bag the appliance
will activate the heating strip automatically and
switch off the pump.
When the manometer shows the minimum value,
you can easily open the lid of the appliance.
Cleaning and maintenance
Always remove the plug from the socket before
cleaning the appliance.
NOTE: Never immerse the appliance in water or
any other liquid!
Clean the outside of the appliance with a damp
cloth (water with mild detergent).
Never use aggressive cleaning agents or
abrasives. Do not use any sharp or pointed ob-
jects. Do not use petrol or solvents! Clean with
a damp cloth and detergent if necessary. Do not
use abrasive materials.
Clean the ventilation slots (if applicable) with the
vacuum cleaner.
Warranty
Any defect affecting the functionality of the ap-
pliance which becomes apparent within one year
after purchase will be repaired by free repair or re-
placement provided the appliance has been used
and maintained in accordance with the instructions
and has not been abused or misused in any way.
Your statutory rights are not affected. If the appli-
ance is claimed under warranty, state where and
when it was purchased and include proof of pur-
chase (e.g. receipt).
In line with our policy of continuous product devel-
opment we reserve the right to change the product,
packaging and documentation specifications with-
out notice.
Discarding & Environment
When decommissioning the appliance, the prod-
uct must not be disposed of with other household
waste. Instead, it is your responsibility to dispose to
your waste equipment by handing it over to a des-
ignated collection point. Failure to follow this rule
may be penalized in accordance with applicable
regulations on waste disposal. The separate col-
lection and recycling of your waste equipment at
the time of disposal will help conserve natural re-
sources and ensure that it is recycled in a manner
that protects human health and the environment.
For more information about where you can drop off
your waste for recycling, please contact your local
waste collection company. The manufacturers and
importers do not take responsibility for recycling,
treatment and ecological disposal, either directly
or through a public system.

Other manuals for Hendi 970362

Related product manuals