10
EN
Troubleshooting
If the appliance does not function properly, please check the below table for the solution.
If you are unable to solve the problem, please contact the supplier / service provider.
Fault Possible cause Fault Possible cause
Burner will not ignite: Defective igniter Burner does not burn fully: Gas cylinder is (almost)
empty
Defective thermocouple
Dirty sparking plug Kink in gas hose
Defective pressure regu-
lator
The main gas tap on the
gas cylinder is not fully
open
Empty gas cylinder
Kink in gas hose Defective gas tap
Clogged jet Main jet clogged
Note
• It is to be recommended to replace the gas hose
after 3 or 4 years (see date shown on hose). The
gas hose becomes porous after a time. Also
check the hose for leaks on a yearly basis at
least. Even if the expiration date has not been
expired yet, you must check the condition of the
hose always. In case of damage/cracks you have
to replace the hose immediately. Please make
sure that you comply with all local health and
safety regulations (e.g. fire code).
• Pressure regulators have a default maximum life
span as indicated by the date printed on the regu-
lator, but please note that local health and safety
regulations may overrule this.
• Only replace the pressure regulator with one pro-
vided by the manufacturer.
• Consult the local regulations, these may differ.
• Always store gas bottles upright, in use as well
as when empty.
• Use only original parts when replacing or chang-
ing parts.
To Next Page
Loading...
