Hensel EXPERT D 500 - User Manual

U S E R M A N U A L //
Compact flash unit
// EXPERT D 500 / D 1000

Summary

Safety instructions

Set-up and initial operation

Critical steps and precautions for safely setting up and operating the unit for the first time.

Working with the equipment

Technical data

Initial use

Power supply

Operation

Switch on;off

Instructions on how to power the compact flash unit on and off using the main switch.

Modeling light

How to operate the modeling light, including FULL and PROP settings.

Performance output adjustment

Synchronization

Synchronization via cord

Synchronization via slave

Synchronization via radio remote trigger

Operation Strobe Wizard Plus

Output adjustment

Switching the modeling light

Operation with freemask

Settings for the freemask method

Configuration for the freemask method, including work stations and camera settings.

Operation with Profoto Air

Channel setting

Setting group

Remote control

Setting power output

Adjusting the power output of controlled flash units remotely using the transmitter.

Flash head on;off

Setting the modeling light

Maintenance

Replacing fuses

Instructions and precautions for replacing fuses in the flash unit, including correct fuse types.

Replacing flash tube

Replacing modeling light

Error messages

Error E4 Unit does not flash

Troubleshooting steps for the E4 error code indicating the unit is not flashing.

Error E5 Unit is overheated

Troubleshooting steps for the E5 error code related to the unit overheating.

Internal faults of unit

Customer service points

Manufacturers service

Accessories

Hensel EXPERT D 500 Specifications

General

Power	500 Ws
Color Temperature	5500 K
Voltage Range	100-240 V
Flash Duration	1/800 s - 1/5000 s
Recycling Time Max	1.2 s
Recycling Time	0.05 - 1.2 s
Modeling Light	300 W