ADLY MOTO 2-6
CHECK AND ADJUST
Rear Light Assembly
• Remove 2 hex bolts.
• Remove 3 L/R sides body cover.
• Disassembly the connection head of
wireness rear light.
• Assembly with the sequence in
reverse of disassembly.
WARNNING:
6 Ensuring the joint of tail light hole
correct with the bulge of truck.
Handle Covering
• Remove 4 self-tapping screws ,
separate the joint with speedometer.
• Remove the handle covering.
• Assembly with the sequence in
reverse of disassembly.
WARNNING:
6 Aim handle covering correctly the
handle covering back’s joint.
To Next Page
Loading...